Products 1-7 of 7
Common Sense RC
Item #: Z-45 -
All Z-series controllers are fully programmable with the throttle stick. Amp Rating 45A Operating Range 2-5S LiPo 6-12 NiCad/NiMH BEC Current 2.2A Length 60mm Width 28mm Height 8mm Weight 1.3oz. 0-Z-45 Instructions ...
Item #: gpmm1800 -
This is the ElectriFly Silver Series 8A Brushless Electronic Speed Control.Great for small, lightweight, high performance airplanesfrom flat-foams to built-up 3Ds. Great for Outrunnerstyle Brushless Motors, delivering 8A of continuouscurrent with a built-in Battery Eliminator Circuit whichcan handle 1.5A. Simple to use and very affordable.FEATURESCompatible with NiCd, NiMH and LiPo batteriesAuto-detects input volts and sets Low-Voltage cutoff8.5kHz switching frequency, for good run-time and...
Item #: GWESC25A -
Built in Battery Eliminator Circuit (5V-2A) For use with 2-4 Cell LiPo battery or 5-12 cell NiMH or NiCd Specs Continuous Current 25A Burst Voltage 30A Voltage Range 6-18V BEC 5V - 2A Size 40 x 24 x 10 mm Weight 18g (.64oz) 0-GWESC25A Manual ...
Item #: SWDRBK -
Mounting brackets made for the Robot Power Sidewinder speed controller. Set of 2 brackets.0-SWDRBK
Ion Motion Control
Item #: R0403 -
The RoboClaw 2x5 Amp is an extremely efficient, versatile, dual channel synchronous regenerative motor controller. It supports dual quadrature encoders and can supply two brushed DC motors with 5 Amps continuous and 10 Amp peak. With dual quadrature decoding you get greater control over speed and velocity. Automatically maintain a speed even if the load increases. RoboClaw also has a built in PID routine for use with an external control system.RoboClaw is easy to control with several built in...
Item #: SHB-01 -
Add this servo amp H-bridge and a 5K potentiometer to any small motor, and you can turn it into an R/C style servo!Control = R/C control 1.1mS - 1.5ms - 1.9msChannels = 1 (single motor controller)Voltage = 4.8vdc - 6.0vdcContinuous Current = ~2amps/6.0vdc (estimated)Peak Current = 4.8amps/6.0vdc0-SHB-01
Item #: 767 -
This lower-power, smaller, and lower-cost version of the TReX is the ultimate general-purpose motor controller for small motors: it has a wide operating range (5 to 24V), delivers 2.5A continuously per motor, provides current sensing on the two main channels, and it features the TReX triple interface that allows you to control motors from a serial line (RS-232 or TTL), radio control (RC) receiver, or analog voltage source such as a potentiometer.The TReX Jr Dual Motor Controller, a...