Spike Relay Module

Spike is a 20A single-channel relay module that is small enough to be remotely mounted almost anywhere on your robot. Spike is designed for on/off operation of a remote device, such as solenoids, pumps, or lights. Because it also includes reversing circuitry, it can also be used to drive small motors in forward, reverse, or off. The unit is opto-isolated, minimizing interference.

This unit requires the relay outputs of the IFI Robot Controller.

Solid State Relay

This is a general purpose 0-60V Solid State Relay (SSR) module designed for the Isaac16 or Isaac32 control systems. The SSR has a single-pole, single-throw function and is rated at 7 amps continuous. The SSR is controlled by one of the Isaac relay outputs. Common uses are for turning on solenoids or large mechanical relays. Requires a PWM/Relay Extension Cable for connection to the Robot Controller.

PWM Cable Clip

Hard, jarring impacts in battle can pop loose your bot's cable connections, especially the place where your PWM cable plugs into your IFI Speed controller.

This clever device locks your PWM signal cables onto all of your IFI speed controllers.

It is made of stainless steel and weighs next to nothing. Simple installation and removal in seconds.

This clip can be the difference between winning and loosing. Grab one for each of your IFI speed controllers (sold individually).

Don't let a loose PWM cable ruin your match!

Aluminum Fan Protector

Long-time users of the IFI speed controllers know that the key to success is make sure that tiny fan NEVER stops. If it does, you risk damage or meltdown. This tiny guard may be the best thing you can do to protect your IFI speed / spin controllers.

Weighing next to nothing (less than 1 gram each), this thin, yet rigid, aluminum guard will protecct your fan from the rigors of battle, preventing one of the most common failures of the IFI controllers- the fan breaking apart. Combine this with one of our nearly-indestructible BattleFans, and you have a perfect setup for your IFI controller.

Works with any of the IFI-comaptible fans, including the Low-Profile version.

This fan protector is endorsed, and DESIGNED by Robotic Death Company as suitable for use in their champion robots.

Simply use your existing screws, bolt this down on top of your fan. It may mean the difference between winning and losing; continuing battle or ending up with a pile of burned electronics.

Spare IFI Fan

All Victor 883's use these fans to control heat dissipation. These small, high power muffin fans are a replacement for the fans on any Victor 883. Manufacturer: Comair - Rotron.

36 inch PWM Extension Cable

Made of large gauge wires, they are designed to take a beating in robotic applications. Use these cables for connecting Victors, Thors or Spike Modules to your receiver. Note that some radio control systems will require a higher signal output, so you may want to use the Signal Booster cable instead.

36 inch PWM Signal Driver Cable (signal booster)

Use in place of the standard PWM cable if you use a non-IFI receiver.

The PWM Signal Driver is required to properly drive the Victor & Thor controllers, depending on your Futaba or similar RC receiver.

This device accepts an R/C receiver's PWM signal and sources the current required to drive the Victor & Thor 883's input. This is a very small device inline with a PWM cable.

24" PWM Y-Cable

Use to split a single signal to two controllers.