Item #: EFLA1080B
UPC: 605482053102
Retail: $139.99
Price: $103.99
You Save: $36.00 (25.7%)
    Points to Purchase: 14856
    Availability: Available
    Usually ships In 3-9 business days (sooner, if drop-shipped)

    Up to 80 amps continuous current with proper air flow and 100 amps burst current (15 seconds)
    5V switch-mode BEC capable of 5 amps continuous current with 6 amps max burst on any recommended input voltage
    Drive up to 7 analog or 6 digital standard-size servos with the BEC on any recommended input voltage
    3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
    Programmable motor braking
    Safe power-arm mode prevents accidental starts
    Programmable low voltage cutoff with settings for 3-cell Li-Po (9.2V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage
    Programmable throttle input range (1.1ms–1.9ms or 1.2ms–1.8ms)
    Programmable soft start-up rate - .25 second or 1 second
    Auto motor shut down if signal is lost or there is interference
    Programmable timing5 user-selectable ranges–use with a large variety of brushless motors
    Two operating modes–Airplane or Heli
    Pre-wired connectorsE-flite EC5 on battery input and 4.0mm female gold bullets on motor output leads

    When performance matters in your high-current applications, look no further than the E-flite® 80-amp Pro switch-mode ESC. This is a high-quality, efficient sensorless brushless electronic speed control with an integrated switch-mode BEC. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication. It is capable of up to 80 amps continuous current when using 3- to 6-series Li-Po battery packs. You can drive up to 7 analog or 6 digital standard-size servos with the BEC on any recommended input voltage. Featuring an exposed, finned heat sink aluminum case with lightweight plastic end-caps, safe power-arming along with advanced programmable features such as low voltage cutoff, braking, timing, throttle input range and more, the E-flite 80-amp Pro switch-mode ESC is truly a ‘pro series' electronic speed control.

    This product is not intended for use by children under 14 years of age without direct adult supervision.

    Forward: Yes
    Brake: Yes
    Time Delay Brake: Yes
    Continuous Maximum Current: 80A
    Input Connector Types: EC5, 10AWG
    Output Connector Types: 4mm gold bullet, 12AWG
    Momentary Peak Current: 100A (15 seconds) Proper Cooling Required
    Length: 3.0 in (77mm)
    Width: 1.6 in (41mm)
    Height: 0.62 in (15.5mm)
    Weight: 3.75 oz (106 g)
    BEC Voltage: 5.5 Volt switch-mode
    Overload Protection: Yes
    Wire Gauge: 10 awg input leads; 12 awg output leads
    Cells w/BEC: 9- to 18-cell Ni-MH, 3–6S Li-Po
    Auto Cutoff: Yes