Arguably
the most popular radio-controlled switch interface out there! Use this
tiny (less than 1/3 oz!) RCE200 to plug into your RC receiver, and
turn something up to 60VDC on and off. Great for remotely-operating
some of our smaller solenoids or relays.
Small
dip-switches provide four
threshold positions with an LED to aid in setup. Fault detection safely
switches off load if receiver signal is lost - doubles as a failsafe!
Powered by R/C receiver drawing only 13ma. Switched load is optically
isolated from R/C circuit.
An
RC Servo lead (10" long)
is already soldered to this unit-
you only need to solder on your input/output wires! Price
reflects the addition of this servo lead. Connector is universal
Futaba/JR style.
Do not exceed ratings, so choose your model carefully:
| |
A-Model |
| Max
Load rating |
4.5A |
| Max
Switched Voltage |
20V |
| Switch
resistance |
0.040
ohms |
| Width |
0.6" (15mm) |
| Length |
1.6" (41mm) |
| Weight |
0.31
oz with RC cable |
| Supply voltage |
3.8 - 5.5VDC |
| Supply
current |
13ma |
| Switching
time |
5
milliseconds |
Simple
to set up, read the data sheet for
further information. One
3/4" piece of clear heat shrink tubing (included) is a great way to
insulate your RCE200.
|
40 Amp Relay
Relay Harness